Compur Gas Generator Manuel d'utilisateur télécharger pdf (Page 13)

4.2.3

COCl

and SO

Generator (see Picture 3)

1 Unplug the external battery (COCl

only).

2 Loosen the 4 screws on the backside of the instrument and separate the two halves. (Use

caution as the LED’s are attached to the top case)

3 Remove the battery.

4 Push back the 2 isolation tubes and unsolder the generator cell from the wires.

5 Unscrew the clamp (KS) and push the generator cell backwards. Remove old generator

cell.

6 Insert the new generator cell and fasten the clamp.

7 Solder the wires to the new generator cell (polarity of no importance) and push the

isolation tubes back over the connections.

8 Insert the battery.

9 Close the housing and tighten the screws in the back. Reconnect the external battery pack.

Note:

) Whenever you have done maintenance work on a gas generator, test the function with a

working gas detector. The detector should give an alarm within 10 seconds.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Compur Gas Generator Manuel d'utilisateur Page 13